Enjoy 20% off with a $60 purchase on our Garden Tools this week. 

Order Your Almanac Today!

How to Choose and Use a Paintbrush

Choosing and Using the Right Paintbrush

Tom Dvorak
Print Friendly and PDF
No content available.

The following 10 pointers on how to choose and use paintbrushes are crucial to a seamless, low-stress painting project.

  1. Don’t spend less on a brush than the cost of a gallon of paint. (The term throwaway brush should not be in your vocabulary.)  It may be tempting to buy a cheap brush but trust us. There is a huge difference in a quality brush.
     
  2. Use natural-bristle brushes for oil-based paints. Nylon or polyester filament brushes are best for latex paints. 
     
  3. The length of the exposed bristles or filaments should be at least equal to the width of the brush. Longer, fatter brushes pay off in fewer trips to the pail, because they lift more paint than short, thin brushes.
     
  4. For large areas, use a three- or four-inch brush. In the long run, a three-inch brush is less tiring and can be used in more places than a four-inch brush. Paint smaller trim with a two-inch angular brush.
     
  5. Your brush is only as good as the tips of its bristles or filaments. Never stand a brush in paint or in storage. Instead, hang it from the handle hole.
     
  6. Never use your brush as a stirring stick.
     
  7. Never scrub your big brush edgewise on the overlaps of clapboard siding. Not only will this ruin the brush, but sealing the overlaps can lead to peeling paint when moisture is trapped behind the siding and forces its way out through the boards.
     
  8. There’s no need to drown your brush in paint. Dipping it halfway into the paint pail is sufficient. Some painters only dip the first inch or two as you don’t want to gunk up the brush with excess paint.
     
  9. Don’t scrape your brush against the side of the pail. Instead, tap the inside of the pail with both flat sides of your brush to release any excess paint. 
     
  10. Choke up on your brush handle, holding the brush as close to the bristles without actually touching them; this increases accuracy.  Hold towards the unpainted surface at about a 45-degree angle. Stroke the paint from the dry area through the wet edge of the previous stroke, then smooth it with a backstroke.

Now, how much paint should you buy for your project? See our article, “How Much Paint Do You Need?”

Read Next

Home Improvement
About The Author

Tom Dvorak

Tom Dvorak, a civil engineer, also writes for Family Handyman about DIY home improvement. Read More from Tom Dvorak
 

No content available.
More Like This

Comments

Color Box (not verified)

4 years 7 months ago

If you're painting a larger wall area with a paintbrush rather than a roller, you will use a different technique to apply and distribute the paint. Try to press the brush against the wall just enough to flex the bristles. Your article is so interesting. Thanks for sharing it.

unclefungus13 (not verified)

14 years 5 months ago

I have some brushes that are over 20 years old. The trick to that is, making sure you clean ALL of the paint from the brush. EVERYTIME. To do this,place the whole brush in clean water(or thinner),turn upside down, and bend the bristles, forcing the water through the ferrule until there is only clean water. This may take a few buckets of clean water, but it is well worth it. Use a wire brush to remove any dried paint from the bristles. Making sure that you go from the ferrule to the tips of the bristles. NEVER go sideways with the wire brush. Let air dry and then wrap back in original cover. If the cover is lost or wears out. Use paper without ink in it. Masking paper works well. With use, your brush will actually take on it's own personality.

When rolling out a room while you're painting use your brush and a dabbing motion by the switch plates that way you don't need a brush stroke a lesson for today by a painter that's been painting for over 40 years like what you left want to leave my thoughts thank you